Titanium glue in bolt with ring Vertical Evolution 10 x 80mm

This titanium glue in bolt with ring is made by the Italian manufacturer Vertical Evolution. Bolting.eu is the exclusive distributor for the Italian manufacturer in the German-speaking regions.

The hook is made of titanium. This means it is made of the perfect material for bolting near the sea. Titanium is currently the best material available. Titanium is an element in its own right and not steel! Its properties make this material extremely resistant to corrosion. Titanium has therefore emerged as THE material for drilling materials near the sea.

This glue in bolt fulfills the function of a lower off / abseil point and must be attached in pairs.

Areas of application Titanium glue in bolt with ring

The positive material properties make the glue in bolt perfect for bolting by the sea!

• Greece like Kalymnos or Leonido
• Sicily like San Vito lo Capo
• Sardinia like Calagonone
• Croatia like island Hvar, Limski Kanal, etc.
• Thailand like Ton Sai, Koh Yao Noi,…
• Sea Stacks in Scotland

Set titanium glue in bolt with ring correctly!

If you want to bolt a climbing route, you should be very careful. This is because setting up a climbing route with glue in bolt harbors the potential for mistakes.

Firstly, start with a high-quality SDS drill bit. This is the only way to get an exact, round drilling hole. For example, use the Fischer Quattric II. This is the only way to achieve an even contact with the injection mortar.

Secondly, the borehole cleaning is done meticulously. Firstly, remove the drilling dust with the drilling hole blow out pumb out. Secondly, make further cleaning passes with the hole brush or Fischer brush. Thirdly, blow out again, voila!

Drill hole diameter when used injection mortar

The titanium glue in bolt with ring requires a drill diameter of +4mm to the hook diameter.

Hook dimension – required drilling hole diameter – drilling depth:

• 10 x 80mm – 14mm – 90mm

Countersink and glue the carabiner eyelet!

When processing the titanium glue in bolt with ring, there is often the same mistake. The carabiner eyelet is not countersunk or glued. Hence our warning. Firstly, drill out the small channel of the drilling hole vertically downwards. Then clean this slot well. Thirdly, after inserting the hook, spread the adhesive that oozes out well around the eyelet. This protects the hook much better, especially against radial forces!

Features titanium glue in bolt with Vertical Evolution ring

• Dimensions: 10mm x 80mm
• Ring: 32mm inner diameter and 10mm thickness
• Material: Titanium
• Weight: 136 gram
• breaking load: 30kN
• required drilling hole diameter: 14mm
• recommended drilling hole depth: shaft length + 10mm

Titanium glue in bolt to order

Are you planning larger bolting or remediation projects near the sea? Then you are welcome to place an order with us. This means that we can supply a wide range of titanium materials with sufficient lead time. We are also happy to produce larger quantities or other dimensions and models.

Here you will find all our titanium drilling materials. As we distribute Vertical exclusively in German-speaking countries, you cannot order directly from the manufacturer. Therefore, please contact bolting.eu directly.

Link Tip: expansion bolt DAV brochure