CT Belay Station 10mm climbing anchor (Kopie)

The CT Belay Station is an EN 959 standardized 10mm climbing anchor made of AISI 316L stainless steel. This means that this product is ideal for climbing garden holders.

This lower off is equipped with bolt hanger equipped with a 10mm hole. It can be attached in all hard rocks with the appropriate expansion bolt.

It also has a fixed steel carabiner, also made of stainless steel. It is theft-protected thanks to its splint. This is hooked directly into a ring.

In short. A high-quality and ready-made solution for your climbing areas! Also available as a version with 12mm bolt hanger!

Features CT Belay Station Plate 10mm climbing anchor

• Manufacturer: Climbing Technology
• Material: AISI 316L stainless steel
• Standards EN 959
• breaking load Strap or ring: 25 kN
• breaking load Carabiner closed: 30 kN
• Carabiner standard: En 362, EN 12275
• 3 chain links á 9cm = 27cm length
• Bolt hanger with 10mm hole
• screwgate carabiner with splint – theft-protected
• Ideal for climbing frame holders
• Ring also ideal for use with a webbing sling, e.g. redundant hanging back of a screwgate carabiner!
• Operating instructions

10mm vs. 12mm

From a technical point of view, a climbing anchor with 10mm expansion bolt is completely sufficient.

The setting depth, dimensions and breaking loads fulfill the EN 959 standard for solid rock. Therefore, 12 mm is only required in exceptional cases. For example, in the case of deliberate “over belaying” or increased setting depth. For example, when the rock is poor on the surface.

Ideal for climbing frame holders

If you are planning to build a climbing area, you’ve come to the right place.

This 10mm climbing anchor has the EN 959 standard throughout, making it ideal for climbing frame holders. However, you must also carry out the checks and maintenance required by law in Austria.

These are, on the one hand, the recorded annual inspection. And on the other hand, keeping a route book – maintenance book.

Theft-protected carabiner

The steel carabiner on this 10mm climbing anchor is theft-proof. This is because it is secured with a fixed splint. This means it cannot simply be removed from the abseil ring.

For refurbishments, the splint must then be bent. It cannot be opened with an Allen key.

Installing the CT Belay Station Plate correctly

Observe the two most important basic rules when installing climbing anchors.

Firstly. Never tension the chain between the plates. Always ensure that there is a little slack in the chain!

Secondly. The top flap must be slightly offset. This creates a V with an angle. This may be a maximum of 45°.