climbing anchor glue in bolt with 2 rings

Our climbing anchor glue in bolt with 2 rings is perfect for quick installation. Because this lower off has glue in bolt with the dimension of only 8 x 80mm. This means you only need a diameter of 10mm drilling hole or a drilling depth of approx. 9cm.

You can only install this status with injection mortar install. It is unsuitable for glass mortar cartridges. We recommend it for alpine projects due to its low weight of only 457 grams.

Due to the glue in bolt dimension of 8 x 80mm, it is suitable for all compact rock types. Finally, the two rings offer a perfect geometry for abseiling. This is because the lower ring protrudes 90° from the rock and is therefore exposed. This means that the rope can be pulled off with minimal friction.

In short. The perfect climbing anchor for alpine projects with long ascents or where battery consumption is low.

Features climbing anchor glue in bolt with ring

• Manufacturer: Vertical Evolution
• Material: AISI 316L steel
• Weight: 457 gram
• glue in bolt Dimension: 8 x 80mm (drilling hole only 10mm)
• Welded rings 10mm thick / 30mm inner diameter
• breaking load 25kN
• Only to be installed with injection mortar
• Ideal as abseil anchor as the 2nd ring is exposed

Perfect for alpine routes

Our climbing anchor glue in bolt with ring is perfect for alpine projects that need to be glued. On the one hand, the stand weighs just 457 grams glue in bolt is only 8 mm thick. This means firstly only 10mm drilling hole width. Secondly, low battery consumption. And thirdly, only low injection mortar consumption. So you can be relatively “light” on the road here.

And on the other hand, the belay with its two rings is perfect for abseiling. As already mentioned, the lower ring is exposed. This means no jamming of the climbing rope, minimal friction when pulling off and no abrasion of the material due to the constantly rotating ring.

climbing anchor glue in bolt with 2 rings = Longlife

Our stand is made of high-quality AISI 316L stainless steel. It also has a double passivation. This means it has an extra thick corrosion protection layer.

Compared to other manufacturers, this treatment (double acid bath) is standard with us and does not cost a cent extra. It guarantees an extremely long service life, which in the Alpine region is many decades.

Correct installation

The climbing anchor glue in bolt with 2 rings must, like all materials to be glued, be processed with the utmost care. With this hook dimension, the rock substrate should be properly compact. For example, porous conglomerate or sandstone are not suitable for this small dimension. Solid limestone, slate or gneiss / granite are best suited.

Clean drilling hole cleaning with a brush and blow out pumb is crucial. Carry out at least three cleaning processes in each case!

Then drill out the channel on the side of the rock for the hook eye to protect the hook against axial twisting. Fill in enough injection mortar so that it swells nicely. Lubricate the hook eye and you’re done!